Welcome to part 2 of this two part series showing you how to remove and install a new toilet tank and bowl.
If you haven’t seen part 1 check it out here:
How To Remove and Install a Toilet Tank and Bowl – Part 1
It’s time to remove the wax gasket and you can do this simply by using a flat blade paint scraper or putty knife. In this video I’m working on a new P.V.C. floor flange, but if you’re working on an old lead or cast iron floor flange I would recommend you inspect it to make sure it’s in good shape before proceeding.
The wax gasket in this demo is in a protective plastic sleeve and not to confuse you; it must be removed from this sleeve before setting it in place. Some plumbers choose to place the gasket onto the male horn of the bowl before setting it into place, but I like to place down on the floor flange. I can see exactly where it’s going to sit and not worry about it accidently falling off while I’m lowering the bowl.
You don’t want to have that gasket halfway on or off the flange, which could happen if it falls off the horn. When I place the bowl down I like to rock it back and forth to set the wax gasket, let me explain why for me it might be a little tougher in the winter months.
I store the wax gaskets in my work van and here in the northeast when the temperatures drop to 30 degrees and below. They get hard as a rock.
A good tip to mention here is that I’ll fill a gallon bucket with some hot water and drop the wax gasket in to bring it back to room temperature.
Once the bowl is securely in place you’re ready to complete the installation. Check out the video for the conclusion and as always if you have questions, you may reach me at info@bobsplumbingvideos.com.
HAPPY PLUMBING!
Leave a Reply