I’m a big fan of Delta faucets and when that very first generation single lever faucet was introduced many moons ago I absolutely loved it. Well made, easy to repair and just an all around good product. A routine Delta repair would consist of a pair of springs, rubber seats, a new ball and you were good to go. Eventually, I would purchase complete repair kits which included all the previous parts mentioned plus all the “O” ring washers and a spray diverter if the faucet was so equipped.
The original Deltas used a solid brass ball unlike the hollow stainless steel versions of today. In both cases the ball had a slot cut into it which would ride on a small brass guide located on the right side of the faucet interior.I would start to get service calls stating that the customer had to play with the handle and position it in exactly the proper spot in order to get the water to stop dripping. I thought this sounds a little flakey, but after taking a close look I figured out what was causing the problem.
The little brass protrusion or guide inside the faucet body would wear down and in some cases become virtually flush with the faucet body. The result being the ball lost its ability to be guided left to right for a positive shut-off. You would have to literally find a “sweet spot” for the handle in order for the water to stop running. I started to realize this would happen more often with the first generation Delta faucets which used the solid brass ball. Because it was one solid mass of brass, it eventually wore down the guide preventing the ball from making a positive shut-off.
If you find yourself having to get that handle in exactly the right position a.k.a “sweet spot” in order for the water to shut after you’ve replaced all the other parts inside the faucet, it’s time to take another look inside. If you find that the guide inside the faucet is pretty much worn down, you’re going to be faced with replacing the faucet. Check out the video below where I show you exactly what to look for. Don’t forget ! if you got questions, I got answers! Forward them to info@bobsplumbingvideos.com and as always,
Happy Plumbing.
Bob.